The lead slead makes it's return SOON!!!

[lucasms313]

Should have my yukon up and running ordered all the parts I need to fix it. And even found a new rear bumper just have to clean it up and shoot a little paint on it Just gotta get the time and a little help to install them. Once that is done it is off to a local off-road shop to fix the problem with the four wheel drive system. So maybe I can finally make a ride.

[Devil_Mutt]

Good deal. Bet your ready to get started. keep us posted with pics as ya go along

[lucasms313]

yeah getting that thing fixed has been long over due but hand some fundage problems. But that seems to be solved now. Will do my best to keep everyone posted on my progress.

[lucasms313]

Got everything installed still can't figure out the miss in the motor but after installing the cam-shaft positioning sensor it is not nearly as bad but the computer is still throwing out the same code as it was when the miss started

[twistedjeeper [Veteran Member]]

wha is the code number you may need to do a relearn post up or pm me and ill see what i can do to help

[lucasms313]

The code is P1345

[twistedjeeper [Veteran Member]]

have you had the dist out could be off by a tooth, shaft could be worn,hold down could be loose, timing chain could have slack the cam and crank dont agree on where the timing is check your harness wires make sure they pluged up right

[lucasms313]

I will check all of that thanks for the help