Mississippi-Mud Forums

and did you get another driveshaft? or are you putting the slip yoke on the 2 piece driveshaft?

I'm putting on the slip yoke. now i need to fab a portable press for the under side or press them on with the t-case out. I'm going to find another t-case with a slip yoke so that i won't have to disassemble the u joints again. anbody want to trade a 208 for another with a slip yoke!!!!!!!!!!!!!!!!!!!!!!!

I'll post some pics of a fabricated mini press and use it on the install later when it starts to dry up a bit.

never made a mini press. i tried using a ball joint press it didn't work too bad. just alot faster with a hammer and an old socket. I'll post some pics tomorrow. over all i had to get a new shaft made for the rear. even after i had compressed more that it should have been it was still too long.

So does this mean that you got your t-case swapped out?

Yea the swap was pretty simple a direct fit. but nothing else seemed to want to work.

sorry no pics were taken though. i'll take some of the new shaft and the old on next to eachother