Mississippi-Mud Forums

Well, the doors were an off white not matchin mine, plus there were scratches that made it through the paint. Yea I might paint the whole thing undercoating so they'll kinda look like "soft" doors? Still need some trimming on the door panels and more paint, and put the inside door handle on. but it's coming along

All this brake work may be done in vein for I PCS in May and may not try to do it before I move. Cause that is my test fit axle that I am using. Plus I have yota axles that I am building for when I get back from Japan so may try and sell this setup? undecided

any one want a disc conversion?

added some more windshiled washers, to make sure I can get the mud off the window

seen some leakage under the zuk before went out, turns out just a few loose bolts on the oil pan and on the transfer case. hmmm.

got me some pedal covers coming to help with grip on em, ooooo

currently workin on my ignition switch. I ran a push button switch for temp but I think I have a bad switch casue I am only gettin 9.8 volts to it. I tried taken it apart to clean it but reckon I only made it worse cause now it only gettin round 7volts go figure. Just so it is in a wee better shape for my pa.

tucked all my wires away with some wire looms. man good times, found out that a 87 ignition switch and a 93 are two totally differnet species. And installed my stock dome light back

replaced my transmission mount with the "unbreakable" from trail tough. I dont think my old one is supposed to seperate like that?