Mississippi-Mud Forums

Well, I've had these ROKMEN corner guards for a few months and finally installed them. Also added a few coats of FUSION to the faded flares.

Before:


After:




Then a little tailgating:

Nice job Mike. I put those one mine as well to cover an "imperfection". Looks good.

So when do we test it out?

Nice! I like em!

Looking good.

lookslike they should work

Tell me more about this Fusion. What is it, where do you get it, and what's it cost? Has your flares looking good.

ya that worked good

fusion is a new spray paint that is made to be sprayed on plastic. you can get it anywhere that sells spray paint

howellru Wrote:Tell me more about this Fusion. What is it, where do you get it, and what's it cost? Has your flares looking good.

Wal-Mart in the paint department. Cheap for how well it worked.

The corners are 3/16" thick steel. Should be more than sufficient to protect my corners for my use. The main reason I put them on was to cover the carnage below. I hammered most of it out and primed it the day it happened, but never finished it. I don't like bondo, so I straightened it fairly well, coated with spray on bed liner, and covered it up with new steel. Thanks for the comments everybody. It feels good to get it done.