Mississippi-Mud Forums

Do you reckon it was making funny noises? :razz:

shouldn't this be in the for section? lol

Replaced the passenger side 4wd axel and wheel bearing. Started degreasing the engine parts today with gasoline and drain-o... then started deglazing the cylinder walls.

Gasoline and drain-o huh. I'm takin it there aint too many DEQ or EPA folks in your area, huh.

Devil_Mutt Wrote:Gasoline and drain-o huh. I'm takin it there aint too many DEQ or EPA folks in your area, huh.

Na He us up there in benton county. Big difference up there. Its not to far from the Hattchie Hills, where ATF wound not even think about going.

True

What? aint nohtin out here for them to be afraid of ive seen the law out here...twice...........ever. funny thing both for murders lol. Hey rowdy i got a good 2.9 motor trans and transfer case so if you need some parts let me know

Finished sandblasting the frame and applied the Imron black paint. Purchased some manual Li/Lo Hubs and painted them gloss black.

Very INTERESTING thread, keep it comin!

The engine rebuild kit arrived today. Put the rings on the pistons and installed them. Installed the new oil pump.